What Chain Reactions Will Be Caused By Water Channeling In Egr Valve?
What Chain Reactions Will Be Caused By Water Channeling In Egr Valve?
2021-12-19
The Engine Of A Used Car Suddenly Locks Up Because Of "It"
The Engine Of A Used Car Suddenly Locks Up Because Of “It”
2021-12-19
Accelerator Pedal

Can you handle the fault code of low / high accelerator pedal signal voltage?

Accelerator Pedal

If you don't have a clear idea, take a look at the technical manual of Accelerator Pedal "Weichai WP10 Bosch edc7"?

                                                           Pre inspection

                                               1 、The battery is fully charged

                                              2、 All vehicle fuses are normal

                                              3、 All connectors are normal without looseness or pin corrosion

                                                          Testing tool

                                              1、 Multimeter, connector adapter, diagnostic instrument

                                             2、 Jumper box

                                             Data flow and normal values:

                                             If the diagnostic instrument is available, read the actual values of the following sensor signals:

Accelerator Pedal
Accelerator Pedal

1、Power supply inspection of accelerator pedal

  1. turn the ignition switch to off
  2. pull out the sensor connector
  3. and turn the ignition switch to on
  4. Measure the voltage of the power supply pin (measured directly from the connector at the harness end)

                                                                       3 component inspection

                                                        3.1 signal voltage detection

                                                        3.1.1 turn the ignition switch to off

                                                        3.1.2 and plug in ECU connector

                                                        3.1.3 plug in the accelerator pedal sensor connector

                                                        3.1.4 place the ignition switch in 0n gear

                                                        3.1.5 read the signal voltage value of position sensor 1 and accelerator

                                                        pedal position sensor 2 and the calculated opening through the diagnostic instrument

                                                                     Note:

                                                       If the corresponding signal value cannot be read from the  diagnostic instrument, please use an additional

                                                      accelerator pedal connector adapter (Y-wire ) to  directly measure the voltage value of the corresponding

                                                      pin of the sensor

Chat with us
Chat with us
Questions, doubts, issues? We're here to help you!
Connecting...
We are Sinotruksitrak. Please leave your inquiry and your phone. We will give you feedback within 12 hours.
Our operators are busy. Please try again later
:
:
:
:
Have you got question? Write to us! Please leave your phone or what'sApp
:
:
This chat session has ended